Electrode contact cleaning
1. Wipe regularly the end of electrode pins with a soft cloth.
✔ When scale be formed on the end of electrode pins, the product may not operate normally.
✔ In this case, wipe regularly the end of electrode pins with a soft cloth to remove oxidized scale .
✔ Excessive force can break the pins.
✔ This hydrogen pot is a consumable. So after 3-5years of use, the electrode’s durability
may be weakened. In this case you may need to buy new one through the service
center.(compulsory)
Soft cloth
Signal for electrode contact cleaning
If there are minerals or scale on the electrode or pins, it is not working when the pin
picture on the control panel is flashing with red. In this case, clean the electrode using the
guidelines below. It will be working again when the flashing turns off.
2. If the pin is still flashing, replace center of the sponge. Enclosed small piece
of sponge will be same height when it gets wet.
Replace center of
the sponge
Wipe the end of
electrode pins.
22
To Next Page
Loading...