Louvolite R1710 - User Manual

For information on how to programme R1710 Motor with the R1722 or R1723 Remote please see the instructions provided in the box
BATTERY SPECIFICATION: Li-ion battery, 2000mAH, 7.4V.
MOTOR TORQUE/SPEED: 1.1Nm/25rpm
A. Remove grease protector ring by opening the split ring and sliding
off the motor body
B. Fit crown by opening the split ring and slide along the motor body
until it meets the motor head.
C. Fit the drive using the cir-clip to secure in position.
D. Attached motor plate with the screws supplied in either left hand
or right hand orientation as required.
ATTACHING THE SOLAR PANEL
•
Make sure the motor has enough charge to operate the blind.
• Attach the solar panel to the charge port on the motor using the
1.5m charge cable.
•
Place/ x the solar panel so that it is facing direct sunlight.
SETTING UP THE MOTOR
• The side of the motor mount with the SETTING button should face you.
• The motor antenna should be as straight as possible; otherwise the receiving distance will be reduced.
• Charging - The motor works with Li-ion battery, please charge when the motor stops working or falters please charge the motor by charger
Charging time with the charger is 5 to 6 hours. Please do not leave the motor on permanent charge as this will reduce battery performance.
NOTE: On receiving the motor we recommend fully charging.
Setting button (Red)
Charge port
Antenna
SET-UP AND OPERATION WITH R1720 REMOTE CONTROL
MOTOR ASSEMBLY
R1710 MOTOR
programming instructions
Remote Transmitter
CHANNEL#
UP
STOP
DOWN
LIMIT
CHANNEL-
CONFIRM
CHANNEL+

Summary

R1710 Motor Setup and Operation

Motor Specifications and Battery Details

Provides battery specification (Li-ion, 2000mAH, 7.4V) and motor torque/speed (1.1Nm/25rpm).

Motor Setup Guidelines

Instructions on motor mount orientation, antenna position, and charging procedures.

Motor Assembly Steps

Details steps for assembling motor components like grease protector, crown, drive, and motor plate.

Solar Panel Connection and Placement

Instructions for connecting the solar panel to the motor's charge port and positioning it for sunlight.

Remote Control Pairing and Motor Direction

Pairing the Remote with the Motor

Step-by-step guide to pair the remote transmitter with the motor using the SETTING and CONFIRM buttons.

Pairing an Additional Remote

Procedure for pairing a second remote transmitter with the motor.

Changing Motor Direction

Instructions on how to reverse the motor's operating direction using the LIMIT and STOP buttons.

Setting Motor Limits

Set Lower Limit

Guide to setting the motor's lower travel limit using the LIMIT, DOWN, and CONFIRM buttons.

Set Upper Limit

Procedure for setting the motor's upper travel limit using the UP and CONFIRM buttons.

Set Mid-Point Limit

Steps to set a mid-point limit for the motor's travel using LIMIT, UP, and STOP buttons.

Limit Management and Troubleshooting

Delete Mid-Point Limit

Instructions on how to remove a previously set mid-point limit for the motor.

Delete Original Handset on Motor

Procedure to remove the pairing of a previously used remote control from the motor.

Motor Troubleshooting FAQ

Addresses common issues like motor not working (charge battery) or not stopping correctly (reset stops).

Safety Instructions

General Safety Warnings

Important safety instructions for installation and use to prevent injury and damage.

Appliance Usage Restrictions

Guidelines on intended use, approved parts, power supply, and environmental conditions.

Child Safety and Supervision

Precautions regarding children's supervision, preventing play with controls, and keeping remotes away.

Maintenance and Operation Precautions

Advice on regular checks, avoiding damage, proper storage, and operational limits.

Louvolite R1710 Specifications

General

Brand	Louvolite
Model	R1710
Category	Engine
Language	English