Technical
Data
Operation Step Operation Result Illustration
Pairing
remote
control
with motor
PLEASE SKIP STEP ONE AND GO TO THE STEP TWO IF THE MANUFACTURER HAS PROGRAMMED A
REMOTE WITH A MOTOR BEFORE DELIVERY.
1
Press and hold down
the SETTING button on
the motor.
Release this button when
the LED ashes red.
2
Press the CONFIRM
button on the back of
the remote control
When the LED ashes green
the remote will now been
paired with the motor
Changing
motor
rotation
direction
1
Press button and
the button at the
same time to change
the motor direction
Release both buttons when
the Green LED ashes.
The direction will now be
reversed
Set up tilt
range
THE WHOLE LIMIT SETTING MUST BE FINISHED AT ONE TIME
1
Press and hold LIMIT
button on the back of
the remote
Release the button when
the Red LED ashes on the
motor
2
Motor turns in a
clockwise direction and
stops when you reach
the end
Red LED ashes
3
Motor turns in a
anticlockwise
direction and stops
when it reaches the end
Red LED ashes.
Now the limit settings have
been done for both ways
Issue: 1/15
Vertical Blind
Motor Instruction
RF SWITCH
SETTING BUTTON
CHARGING PORT
LED
PRESS AND HOLD 90
O
TO OPEN BLINDS
Battery Specication: Li-ion Battery, 3.7V.
Please charge the battery when the
motor alarm beeps or motor fails
to turn the blind.
Remote Control
To Next Page
Need help?
General
