How to start a warm engine
1. If the engine is equipped with a manual stop control, ensure that
it is in the "run" position.
2. Adjust the engine speed control to the quarter open position.
3. Turn the start key to the "HS" or "S" position to engage the
starter motor;
4. Allow the start key to return to the "Ft" position, as soon as the
engine starts. Always ensure that the engine and starter motor
are stationary before the starter motor is engaged again.
How to start a cold engine
1. If the engine is equipped with a manual stop control, ensure that
it is in the "run" position.
2. Adjust the engine speed control to the maximum speed position.
3. Turn the start key to the "S" position to engage the starter motor.
Allow the key to return to the "R" positron, when the engine
starts. Then adjust the engine speed control to get an even idle
speed.
4. If the engine does not start in 30 seconds, allow the start key to
return to the "R" position for another 30 seconds. Then engage
the starter motor again for a maximum period of 30 seconds.
Attention:
Ether type fuels must not be used at the same time as
a fuelled starting aid.
3.03
To Next Page
Loading...
Need help?
General
