Need help?Do you have a question about the Lowrance HDS-12 HDS Gen3 and is the answer not in the manual?
General| Display Resolution | 1280 x 800 pixels |
|---|---|
| Touchscreen | Yes |
| Networking | Ethernet, NMEA 2000 |
| GPS Antenna | Internal |
| Chartplotting | Yes |
| Power Input | 12V DC (10-17V DC min-max) |
| Waterproof Rating | IPX7 |
| GPS Receiver | Internal 10Hz GPS |
| Sonar | CHIRP, StructureScan |
| Wireless Connectivity | Yes |
| SD Card Slot | 2 microSD slots |
| Display Type | LED backlit LCD |
Copyright notice and year for the manual.
Details regarding the product warranty and customer support.
Statements regarding equipment intended use and compliance standards.
Regulatory information for Canada, including license-exempt device warnings.
Cautionary note regarding modifications and FCC compliance rules.
List of registered trademarks and brand names associated with the product.
Identification of physical buttons, keys, and touchscreen elements on the display's front.
Labels and descriptions of all ports and connectors located on the rear of the display.
Explanation of the function and operation of the microSD card reader.
Guidance on selecting an appropriate and safe location for mounting the display.
Step-by-step instructions for mounting the display using the provided bracket.
Detailed instructions for flush-mounting the display into a panel.
Pre-installation checks and considerations for optimal transducer placement.
Guidance on choosing the optimal location for transducer mounting to avoid turbulence.
Instructions for physically attaching the transducer to the boat's transom.
How to adjust the transducer's angle for optimal sonar performance.
General best practices and safety warnings for electrical connections.
Details on connecting the display to the vessel's 12V DC power supply.
Instructions for connecting the sonar transducer to the display unit.
How to connect other devices via Ethernet for data sharing.
Steps for connecting the display to an NMEA 2000 network.
How to connect devices using the NMEA 0183 serial interface.
Instructions for connecting and configuring a video input source.
Initial setup process including language selection and basic configuration.
How to set the local time and date for accurate logging.
Configuring data sources for GPS, heading, and other sensor inputs.
Displays connected devices and allows for configuration and management.
Tools for troubleshooting network and device issues.
Adjusting data smoothing for stability of readings like speed and heading.
Configuration options for the internal sonar system.
Calibrating the sonar transducer's speed reading to the boat's actual speed.
Selecting the correct transducer model for optimal sonar performance.
Configuration and adjustment settings for the Broadband radar.
Procedure for calibrating fuel flow sensors for accurate readings.
How to manually enable CZone features if not automatically detected.
Setting a unique virtual dipswitch for each CZone device.
Information on synchronizing databases across multiple displays.
Explains how IP addresses are assigned and displayed for network devices.
Managing and connecting remote devices for display control.
Viewing details of connected wireless devices and network settings.
Tools for fault-finding and advanced configuration of the Wi-Fi network.
How to save and restore waypoints, routes, trails, and settings.
Instructions for updating the display's firmware.
Procedures for upgrading firmware on networked devices.
Detailed list of NMEA 2000 Parameter Group Numbers for receiving data.
Detailed list of NMEA 2000 Parameter Group Numbers for transmitting data.
Lists NMEA 0183 sentences that can be transmitted and received.
To Next Page