LOXONE INTERCOM XL User Manual

LOXONE INTERCOM XL
Part No.: 200192
Quick Start Guide
[A] HARDWARE INSTALLATION
1. This information is important for outdoor installation if
using the flush-mounted installation box! - The metal
edge of the box should be sealed against the surface
with the acrylic sealing.
The acrylic sealing must be applied to ensure that no
moisture can enter between the flush-mounted box and
the wall surface.
Additionally, the acrylic must be smooth so that the foam
rubber seal of the mounting frame is resting on an even
surface and no moisture enter in between the foamed
rubber seal and the flush-mounted box through any gaps.
2. Power up the Loxone Intercom XL by connecting a
network cable with the delivered PoE injector. (Power
over Ethernet)
3. Mount the camera on your backbox with the screws
included.
[B] SOFTWARE SETUP
Upon initial start up, the Loxone Intercom will have the
following default settings.
SIP module:
IP-Address: 192.168.1.98
User: admin ; Pass: admin
Video module:
IP-Address: 192.168.1.99
User: admin
Once the Loxone Intercom XL has finished it’s boot up
procedures, please follow the steps below:
1. Start Loxone Config and connect to your Miniserver
2. Click on “Peripherals Search”
The search window will open as below:
3. 1 - Click on the “Network” tab.
This will display all devices found on your network.
(May take a view seconds)
2 - Click on Intercom Video or Audio
loxone.com

LOXONE INTERCOM XL Specifications

General

Brand	LOXONE
Model	INTERCOM XL
Category	Intercom System
Language	English

Summary

Hardware Installation

Powering Up Loxone Intercom XL

Connect the Loxone Intercom XL to power using the provided PoE injector and network cable.

Mounting the Camera

Secure the camera onto the backbox using the included screws.

Software Setup

Default SIP Module Settings

Default IP address, username, and password for the SIP module.

Default Video Module Settings

Default IP address and username for the video module.

Finding Intercom in Loxone Config

Steps to locate and identify the Loxone Intercom XL within the Loxone Config software.

Configuring and Adding Intercom Device

Steps to configure IP settings and add the Intercom XL device to Loxone Config.

Troubleshooting IP Address Issues

How to access the Intercom XL via web browser if not found in Peripherals Search.

Entering Network Credentials and IP

Input username, password, and external IP addresses for intercom functionality.

Integrating into Loxone Program

Using the doorcontroller block and configuring call buttons in Loxone programs.

Configuring Intercom Display Directory

Setting up names to be displayed on the Intercom XL screen via its web interface.

Further Configuration