USER MANUAL | RX-CS6, RX-CS7, & RX-AT9
LRSUS.COM | 4
PRODUCT SPECIFICATIONS
Required Voltage: 110-120V outlet for pager chargers, LRS issued 10VAC, 4.0-4.2A pow-
er supply included in kit
Battery Type: Nickel Metal Hydride (NiMH). Rechargeable.
Battery Life: Approximately 3-5 years
Battery Charge Life: Approximately 24 hours (depends on how often they are paged).
Recharge time: 16 hours minimum from completely discharged.
Operating Range: Up to 1/4 mile
Dimensions: 4.25” x 4.25” x .75”
CLEANING
LRS pagers are made from industrial-strength, polycarbonate material. However, this ma-
terial is susceptible to hairline cracking if non-approved cleaners are used. When clean-
ing LRS pagers, you should only use ETHYL ALCOHOL (ethanol) or ISOPROPYL ALCO-
HOL-BASED CLEANERS. We have done extensive testing with available cleaning materials
and have not found any issues with either ethyl alcohol (ethanol) or isopropyl alcohol
(IPA). ALL other cleaners are not recommended for use on any of our pagers.
To clean the equipment:
1. Take a clean cloth and an isopropyl-alcohol based cleaner
2. Wet the clean cloth with the isopropyl alcohol cleaner
3. Wipe down the pagers or equipment
4. When dry, place rechargeable pagers back on charge
WARNING:
Cleaning your equipment with any other non-approved cleaners can weaken plastic and
cause hairline cracks. Pagers and equipment that are cleaned with unapproved cleaners
and suer cracking will not be covered under warranty. Do not submerge any LRS paging
equipment in any type of liquid as this will also damage the equipment and is not covered
under the standard warranty.
Many alcohol-based sanitizers add quaternary ammonium (aka “quat”) to the mix. Long-
term exposure to quats will damage polycarbonate. A commonly used quat is benzalkoni-
um chloride.
To Next Page
Loading...
General