LS Industrial Systems TS1000N - Trip Relay Settings; Protection Settings

33
4. 온도 센서 3. Terminal Configuration
I. TRIP RELAY Externals and Configuration
Division CN1 CN2 CN3 CN4
Figure
FRONT REAR TOP
1
TTL TX (OCR side) CT-Ir ZSI OUT (+) RS485 (+)
2
Current signal-Ir Power CT (-), GND ZSI OUT (-) DO Relay #1
3
TTL RX (OCR side) CT-Is ZSI IN (+) RS485 (-)
4
Current signal-Is Power CT (+), 24V ZSI IN (-) DO Relay #2
5
Power (+), 24V CT-It Remote reset (+) Spare
6
Current signal-It Delay Contact (-), GND Remote reset (-) DO Relay #3
7
Power (-),GND CT-In RCD (+) Spare
8
Current signal-In Delay Contact (+) RCD (-) DO Relay COM
9
Power (-),GND CT-Ir, Override Vr Power (+)
10
Current signal COM MTD (+),24V Vs Power (-)
11
CT-Is, Override Vt
12
MTD (-) V COM
13
CT-It, Override
14
CT-COM
15
In Override
16
Spare
9 7 5 3 1
10 8 6 4 2