LS Industrial Systems TS1250N - Rotary Handle Installation; D-Handle Type Installation and Testing

25
H. Installation and Handling
6. Installation of accessories and handling
■ Rotary handle
- Direct rotary handle
D-HANDLE TYPE
DH5 TYPE DHK5 TYPE (KEY LOCK)
DOOR
COVER
SCREW,(+)PH,P.S S/W,M4,L20 6ea
SCREW,(+)PH,P.S/W,M6,L16 4ea
SCREW,(+)PH,P.S/W,M6,L12 4ea
LINE
LOAD
L TYPE
LINE
LOAD
S TYPE
LINE
LOAD
R TYPE
HANDLE, ON STATE
1. Disassembling cover
Spare part (사용 SCREW)
①
②
③
④
OFF STATE
RESET or OFF
2. Assembling the D-handle 3. Door Cut Type
A TYPE
SCREW,(+)PH,P.S/W,
M6,L12 4ea
B TYPE
SCREW,(+)PH,P.S/W
M6,L16 4ea
SCREW TAPPING
(+)PH,M4,L28 6ea
①
②
OFF STATE
1.5Nm
(15.3kgf.cm)
4. ON/OFF/TRIP Test
OFF POSITION ON POSITION
TRIP POSITION
RESET POSITION
④
③
①
②
ON
TRIP
RESET
ON
ON POSITION
* Handle ON operating is possible
when the door lock lever is pushed.
Door lock
lever
1. In case of disassembling and assembling the main cover, screw should be tightened in specific torque of1.5N.m (15.3kgf.cm)
2. In case of disassembling and assembling the main cover by over tightening torque, the parts of MCCB can be damaged.