LS Industrial Systems TS1250N - Rotary Handle Locking and Door Cut

26
H. Installation and Handling
6. Installation of accessories and handling
■ Rotary handle
- Direct rotary handle
5. Locking System
• If the door is opened with
much pressure
when the position of handle
is ON or TRIP, the handle
lock lever will be damaged.
Please open the door
after rotating release
lever
open OK
Release lever
Key lock: locking OFF position
Locking at ON or OFF position
OFF State
ON State
door locking
After locking handle, be sure that the key removed.
Ф5~6
6. Dimension of door cut
A TYPE B TYPE
1. In case of disassembling and assembling the main cover, screw should be tightened in specific torque of1.5N.m (15.3kgf.cm)
2. In case of disassembling and assembling the main cover by over tightening torque, the parts of MCCB can be damaged.