LS Industrial Systems TS1250N - Extended Rotary Handle Installation; E-Handle Type Installation and Testing

27
H. Installation and Handling
6. Installation of accessories and handling
■ Rotary handle
- Extended rotary handle
E-HANDLE TYPE
HANDLE
SHAFT
SCREW,(+)PH,P.S S/W,M4,L20 6ea
SCREW,(+)PH,P.S/W,M5,L18 4ea
LINE
LOAD
L TYPE
LINE
LOAD
S TYPE
LINE
LOAD
R TYPE
HANDLE, ON STATE
1. Disassembling cover
Spare part (사용 SCREW)
①
②
③
④
OFF STATE
RESET or OFF
2. Assembling the E-handle 3.Installing Shaft
SCREW TAPPING
(+)PH,M4,L28 6ea
①
②
OFF STATE
1.5Nm
(15.3kgf.cm)
①
②
SCREW
(+)CH,M6,L16
OFF State
of the handle
* Vertical state
of the shaft pin
1. In case of disassembling and assembling the main cover, screw should be tightened in specific torque of1.5N.m (15.3kgf.cm)
2. In case of disassembling and assembling the main cover by over tightening torque, the parts of MCCB can be damaged.