HOW TO CONNET HYDRAULIC LINE
- MT345E/MT350E/MT355E
PART 1. Install Plate
① Bolt(tractor)
② Plate
③ Nipple
④ Quick coupler
⑤ Dust plug
⑥ Teflon tape
STEP 1.
STEP 2.
STEP 3.
STEP 4.
STEP 5.
PART 2. Backhoe Hydraulic P-Line
① Bolt
② Nut
③ Washer-spring
④ Tire(LH)
STEP 1.
Remove the bolts(①) from the tractor.
RInstall the dust plug(⑤) to the quick coupler(④).
Install the plate(②) to the tractor with bolts(①).
RWind up the teflon tape(⑥) on the nipple(③) and tighten the quick coupler(④) to the nipple(③).
Install the nipple(③) to the plate(②) with nut as shown in above figure and tighten these nut and nipple(③).
Remove the hardware(①,②,③) and tire(④) from the tractor.
- 30 -
To Next Page
Loading...
