Display units
R-phase
S-phase
T-phase
Test/Reset
Func
Display
Sel
Current
Time
Load ratio
3-phase current/Trouble cause
2
ᆞ Check the communication cable to insert smoothly.
ᆞ Combine the display units with the main units in tight,
Or its Relay contact is opened.
ᆞ Please check the relay by pressing the TEST/RESET Key before
running the Motor,
ᆞ Insert the finger proof necessarily in the terminal block,after
wiring in case of screw type products.
ᆞ Refer to wiring diagram for proper terminal
connection.
ᆞ After wiring, Cover the Finger Proof necessarily.
ᆞ Use the product in a range of the rated voltage and current
shown on the name plate.
It may cause a malfunction.
ᆞ When the device useless, it should be dispose of them as
an Industrial waste.
!
CAUTION
To Next Page
Loading...