INSTALLATION, OPERATION AND MAINTENANCE MANUAL
FW cooling only range – Monosplit single-phase
Caution: the use of a manual that is not up to date with the condensing unit version does not
engage the responsibility of LTB
1 INTRODUCTION
The present document constitutes the installation, operation and maintenance manual for the following water
condensing units:
FW07Q6 (model code WQF101).
FW09Q6 (model code WQF102).
FW14Q6 (model code WQF103).
FW18Q6 (model code WQF104).
FW24Q6 (model code WQF105).
FW36Q6 (model code WQF106).
A water condensing split system consists of:
An indoor unit (IU) which can be a wall mount unit, ceiling cassette, ducted indoor unit or floor
mounted/ceiling console.
A condensing unit (CU) connected to the water network (town water, water loop).
The fitting must be carried out by a person with the right competences and legal capacities. This person
must respect the standing rules and regulations. The builder declines any responsibility and the guarantee will
no longer be applicable if the fitting instructions have not been respected. A case of any doubt or for any
additional detailed information, please contact your local retailer.
2 RECEIPT AND STORAGE OF THE GOODS
Please inspect the goods on receipt before unpacking. Any choc may have caused serious damage to unit's
function which will not be taken under warranty.
In case of any deterioration, detailed reservations must be made and immediately sent
by registered letter to the carrier indicating the damages observed. A copy of the letter
must also be sent to the builder or to the retailer.
The machine must not be carried or placed upside-down. It must be stocked inside and perfectly sheltered
from rain and snow, etc. Weather variations (high or low temperatures) must not damage the unit. Very high
temperatures (from 60°C) may damage certain plastic parts and cause permanent damage. Moreover, certain
electronical components may not function properly.
To Next Page
Loading...