START CHARGING YOUR BATTERY
PLEASE READ CAREFULLY BEFORE USING
Suitable for 12/24V Normal Lead Acid, Sealed, Leisure, Gel or Lipo4 Batteries
between 7-200Ah
1. PREPARING THE BATTERY
• Firstly remove the caps from each cell and check that the level of the liquid is
sufcient in each cell. If it is below the recommended level, top up with de-ionized or
distilled water.
Note: Under no circumstances should tap water be used.
• The cell caps should not be replaced until charging is complete. This allows any
gases formed during charging to escape. It is inevitable that some minor escape of
acid will occur during charging.
For permanently sealed battery, it is not necessary to carry out the above checks.
2. CONNECTION
• Connect the positive charging lead (red) to the positive terminal post of the bat-
tery (marked P or +). Connect the negative charging lead (black) to the negative
terminal post of the battery (marked N or -).
Warning! Always disconnect the AC plug from the AC mains socket before
connecting or disconnecting the appliance to or from the battery.
3. CHARGING
• Connected to power supply and the battery, the charger will automatically enter into
charging status, it is working on slow charging stage for 12V batteries by default. The
slow charge icon will illuminate, and the charger is automatically detecting the battery.
This is the standard charging mode.
• Within the rst 5’’ after connecting the charger to the power supply you can select a
different charging mode:
1. Hold the Mode key to switch to 24V and back.
2. Pressing the mode key to select one of the nine charge modes.
• After 5’’ the charge starts according to the setting.
4. WHEN CHARGING IS COMPLETE
When the Stage 8 icon and Full illuminates, the battery is completely
charged.
Only for 12/24V Normal Lead Acid, Sealed, Leisure or Gel batteries
The battery charger now switches to the Float mode and doesn’t require your atten-
tion until the next time it is used, it will automatically maintain your battery.
If LCD stage 9 icon illuminates, it indicates that the charger has automatically
maintained your battery.
Switch off the mains supply, unplug the charger, and disconnect the leads from the
battery posts.
To Next Page
Loading...