HD-TVI Dome Camera
User Manual
Regulatory Informaon
FCC Informaon
FCC compliance: This equipment has been
tested and found to comply with the limits for a
digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide
reasonable protecon against harmful
interference when the equipment is operated in
a commercial environment. This equipment
generates, uses, and can radiate radio
frequency energy and, if not installed and used
in accordance with the instrucon manual, may
cause harmful interference to radio
communicaons. Operaon of this equipment in
a residenal area is likely to cause harmful
interference in which case the user will be
requ
ired to correct the interference at his own
expense.
FCC Condions
This device complies with part 15 of the FCC
Rules. Operaon is subject to the following two
condions:
1. This device may not cause harmful
interference.
2. This device must accept any interference
received, including interference that may
cause undesired operaon .
EU Conformity Statement
upon the purchase of equivalent new equipment,
or dispose of it at designated collection points.
For more information see:
www.recyclethis.info.
2006/66/EC (baery direcve):This
product contains a baery that cannot
be disposed of as unsorted municipal
waste in the European Union.
See the product documentaon for specific
baery informaon. The baery is marked with
this symbol, which may include leering to
indicate cadmium (Cd), lead (Pb), or mercury (Hg).
For proper recycling, return the baery to your
supplier or to a designated collecon point. For
more informaon see: www.recyclethis.info.
2012/19/EU (WEEE direcve):
Products marked with this symbol
cannot be disposed of as unsorted
municipal waste in the European
Union. For proper recycling, return
this product to your local supplier
This product and - if applicable - the
supplied accessories too are marked
with "CE" and comply therefore with
the applicable harmonized European
standards listed under the Low Voltage Direcve
2006/95/EC, the EMC Direcve 2004/108/EC ,
the RoHS Direcve 2011/65/E U.
This series of camera adopts new generaon
sensor with high sensivity and advanced circuit
design technology It features high resoluon,.
low image distoron and low noise, etc , which.
makes it suitable for surveillance system and
image processing system.
High performance CMOS sensor and high
resoluon bring high-quality image;
Low illuminaon;
OSD menu, parameters are configurable;
Support auto white balance, auto gain control,
Support image effect adjustment;
Unit transmission control;
Advanced 3-axis design meets different
installaon requirements.
1 Introducon
1.1 Product Features
1.2 Overview
1.2.1 Overview of Type I Camera
1.2.2 Overview of Type Camera
II
2 Installaon
Before you start:
Please make sure that the device in the package
is in good condion and all the assembly parts
are included.
Make sure that all the related equipment is
power-off during the installaon.
Check the specificaon of the products for the
installaon environment.
Check whether the power supply is matched
with your power output to avoid damage.
Please make sure the wall is strong enough to
withstand three mes the weight of the camera
and the mounng.
If the wall is the cement wall, you need to insert
expansion screws before you install the camera.
If the wall is the wooden wall, you can use
self-tapping screw to secure the camera.
If the product does not funcon properly,
please contact your dealer or the nearest
service center. Do not disassemble the camera
for repair or maintenance by yourself.
2.1 Installaon of Type CameraI
2.Drill the screw holes and cable hole according to
the drill template.
Figure 2-2 The Drill Template
Screw Hole
Bubble
Video Cable
Power Cable
Adjustment Screw
Camera
Black Liner
Moungng Base
Adjustment Screw
Black Liner
Bubble
IR LED
Lens
Safety Rope
1.Pry the snap joint up to remove the bubble
and the black liner.
Cable Hole
Snap Joint
Figure 2-1 Remove the Bubble
Steps:
Thank you for purchasing our product. If there
are any quesons, or requests, please do not
hesitate to contact the dealer.
This manual may contain several technical
incorrect places or prinng errors, and the
content is subject to change without noce.
The updates will be added to the new version of
this manual. We will readily improve or update
the products or procedures described in the
manual.
Please refer to the product specificaon for
camera parameters and funcons.
Privacy Noce
Surveillance laws vary by jurisdicon. Check
all relevant laws in your jurisdicon before using
this product for surveillance purposes to ensure
that your use of this product conforms.
To Next Page
Need help?
General
