luceco Guardian Slimline PIR

To Next Page

Guardian Slimline

LED Floodlights – PIR

Installation & Operating Instructions

CRI

IP44

RATED

WARRANTY

year

standard

Tech Help Line

UK -

0330 0249 279

Non UK -

+44 (0)1952 238 100

Supplied by LUCECO

Stafford Park 1, Telford,

Shropshire, England, TF3 3BD

Visit our website at

www.luceco.com

LFSP02.JH.11.2017

30,000

HOURS

NOTE – To comply with regulations, installation must be carried out by suitably

qualified competent person and in accordance with the current IEE Wiring

Regulations (BS7671) and Building Regulations. A copy of the instructions must

be left for the user/maintenance engineer for future reference.

For non-UK, please refer/consult local requirements

ENSURE ELECTRICAL SUPPLY IS DISCONNECTED/

ISOLATED BEFORE COMMENCING INSTALLATION

INSTRUCTIONS FOR NEW INSTALLATIONS

1. Turn OFF power supply, ensure all required equipment

and tools are present

2. The floodlight is supplied pre-wired with 1.0M of H05RN-F

cable, removing the need to open the housing

3. The floodlight is intended for exterior use and is IP44 rated.

Select a suitable mounting position. Recommended mounting

height shown in the adjacent table, area illuminated is typically

mounting height x3

Lumens Height Suggested Halogen Equivalent

600 2.0m - 3.0m 100W

1200 2.5m - 4.0m 200W

1800 3.0m - 5.0m 300W

3000 4.0m - 6.0m 500W

4. This product is supplied with a long bracket fitted by standard.

With a suitable mounting position:

a) Tilt floodlight forward in the bracket to allow access

to the bracket

b) Fit bracket to wall using suitable fixings (NOT SUPPLIED)

c) Tilt floodlight to desired angle and tighten fixing bolts

5. Connect the pre-wired cable to the electricity supply, observing

the correct polarity:

LIVE = BROWN

NEUTRAL = BLUE

EARTH = GREEN/YELLOW

Note - This product range is design for domestic outdoor use.

Not suitable for interior or commercial use. If outdoor

connection is required, use a suitably IP Rated junction box.

b c

Need help?

Do you have a question about the luceco Guardian Slimline PIR and is the answer not in the manual?

Summary

Instructions for New Installations

Preparation and Mounting

Turn off power, gather tools, select position, and mount bracket using suitable fixings.

Wiring Connections

Connect the pre-wired cable to the electricity supply, observing correct polarity for Live, Neutral, and Earth.

PIR Adjustments

Time ON Adjustment

Controls floodlight illumination duration after movement is detected, adjustable from 10 seconds to 8 minutes.

Ambient Light Adjustment

Controls when PIR detects movement based on ambient light level, adjustable from 2 Lux to 2000 Lux.

Override Facility

Initiate Override

Initiate Dusk till Dawn mode by cycling power OFF/ON/OFF/ON within 2 seconds.

Disable Override

Disable override and reset to full automatic PIR detection by turning power off for a minimum of 5 seconds.

Warranty and Environmental Information

United Kingdom Warranty

Details the 2-year warranty against defects, repair/replacement process, and exclusions.

Environmental Protection

Guidance on proper disposal of electrical items using separate collection schemes (WEEE symbol).