luceco SOLAR GUARDIAN User Manual

SOLAR GUARDIAN FLOODLIGHT
3.2W WALL LIGHT WITH PIR
Installation & Operating Instructions
1
WARRANTY
year
standard
IP44
RATED
NOTE – To comply with regulations, installation must be carried out by suitably
qualified competent person and in accordance with the current IEE Wiring
Regulations (BS7671) and Building Regulations. A copy of the instructions must
be left for the user/maintenance engineer for future reference.
For non-UK, please refer/consult local requirements
ENSURE ELECTRICAL SUPPLY IS DISCONNECTED/
ISOLATED BEFORE COMMENCING INSTALLATION
SUGGESTED METHOD OF INSTALLATION
1. Select flat surface which receives direct sunlight
2. Drill 3 holes of 6mm at the requested place, keep 163 mm
distance between the 3 holes, 2-4m height from ground
3. Fix 3 rawl plugs into the hole (included)
4. Fix a screw to the lower expansion plug with a little spare
space, insert into the screw groove and fix
5. Straighten the whole lamp and fasten the 2 upper
screws tightly
6. Switch On - fitting will turn on and LEDs will illuminate
for a short period before turning off to normal operation
FEATURES & BENEFITS
• Front and rear facing LED technology provides both functional and
ambient illumination
• 3 working modes, defined overleaf
• Long lasting battery life – 6 hours charge provides illumination
up to 3 nights
• Perfect for outdoor entrance areas, balconies, paths and decorative
garden lighting
• IP44 rated with durable impact resistant housing
• PIR detection range 2-6 metres
• No wiring, easy & simple installation
1 – Solar Guardian Housing
2 – 2,3 W Mono-Crystalline
Silicon Solar Cell
3 – PIR Sensor
4 – Front LED Light
5 – Rawl Plug (included)
6 – Screw (included)
7 – Rear LED Light
8 – Screw Groove
www.luceco.com
LEX.RO.07.2017
ACCESSORIES:
(x3)
(x3)
2
3
4
6
1
5
7
8
6
5

luceco SOLAR GUARDIAN Specifications

General

Product Type	Flood Light
Power Source	Solar
Power	10W
IP Rating	IP65
Charging Time	6-8 hours
Material	Aluminum
Working Time	8 hours

Summary

Product Features and Benefits

Front and Rear Facing Illumination

LED technology provides both functional and ambient illumination.

Outdoor Area Suitability

Ideal for entrance areas, balconies, paths, and decorative garden lighting.

Durable Construction

IP44 rated with durable impact resistant housing.

Working Modes

Device operates in three defined working modes.

Extended Battery Life

6 hours charge provides illumination for up to 3 nights.

PIR Detection

Features PIR detection range of 2-6 metres.

Simple Installation

No wiring required, offering easy and simple installation.

Installation Guide

Surface Selection

Select a flat surface that receives direct sunlight for optimal performance.

Drilling and Mounting

Drill 3 holes (6mm) spaced 163mm apart, 2-4m height, insert rawl plugs.

Securing the Fixture

Fix screws into lower expansion plugs and fasten upper screws tightly.

Initial Power-On Test

Switch on; fitting illuminates briefly before entering normal operation.

Product Specifications

Solar Panel Details

2.3W Monocrystalline Silicon solar panel.

Battery Information

Internal lithium battery (3.7V/2000mAh), not user-replaceable.

LED Configuration

30pcs SMD2835 LEDs with a 120° beam angle.

PIR Sensor Specifications

120° detection area, 2-6 metre range, 1-second delay.

Physical Dimensions

Dimensions: 110 x 212 x 140 mm.

Operating Modes

Mode A: Dusk-to-Off

Turns on at dusk (low light) to 80lm, off after 5 hours.

Mode B: Motion Activated Dim

Full brightness (400lm) on motion, returns to dim glow after 20s.

Mode C: Motion Activated Off

Full brightness (400lm) on motion, turns off after 30s.

Warranty Information

Standard Warranty Terms

1-year warranty against material/workmanship defects.

Warranty Exclusions

Excludes damage from misuse, accident, unauthorized repair.

Environmental Protection

WEEE Disposal Symbol

Indicates product not for general household waste; use separate collection.