23
Paging All Phones
1 Press and release a or p.
2 Press and release *.
3 Speak toward the telephone.
4 Press and release K to disconnect.
Answering an ALLPAGE
1 Press a or p.
2 Use the already activated speakerphone, or lift the handset.
3 To end, press and release K or hang up.
Making an Intercom Conference Call
1 Make or answer a call.
2 Press and release I and enter the station number.
3 After the third party answers, press and release C.
4 To end an intercom conference call, hang up.
NOTE: You cannot put an intercom conference call on hold.
Room Monitor
You can activate the speaker of another phone to monitor sounds in that
room.
1 Press and release p.
2 Enter the station number of the telephone to be monitored.
3 Press and release M if you don’t want sounds on your end to be
heard.
4 To end monitoring, press and release K.
Checking Your Station Number
1 Press and release I.
2 Use the dial pad to enter a station number (11 to 22).
3 Press K to hang up.
4 Repeat Steps 1–3 until the intercom light goes off. The last number
entered is your station number.
NOTE: If the intercom light stays on even after you enter numbers 11
through 22, your phone does not have a station number. See “Assign
Intercom Number” in the TELEPHONE FEATURE SETUP section for
assigning intercom station numbers.
INTERCOM OPERATION
Lucent 0954 book.L1 5/7/98, 10:36 AM23
To Next Page
Loading...
