Lucent Technologies SLC 5 Series - Page 227

363-205-401 Power Up: DLP-533
Issue 7, March 1997 Page 5 of 6
23.
!
DANGER:
A high discharge current is present at connector head if TESTING
indicator is lighted. Batteries must not be connected or disconnected
when TESTING indicator is lighted.
Defective test set. Depress
STOP
button, unplug battery. Return test set for
repair.
24. Depress test set
STOP
button.
25. Does test set
STOP
indicator light and
TIME
display stop counting time?
If
YES,
then proceed to Step
27.
If
NO,
then continue with Step
26.
26.
!
DANGER:
A high discharge current is present at connector head if TESTING
indicator is lighted. Batteries must not be connected or disconnected
when TESTING indicator is lighted.
Defective test set. Allow test to run for 15 minutes as shown on
TIME
display.
When
COMPLETE
indicator lights, unplug battery. Return test set for repair.
27.
!
DANGER:
A high discharge current is present at connector head if TESTING
indicator is lighted. Batteries must not be connected or disconnected
when TESTING indicator is lighted.
Depress test set
START/CONTINUE
button.
28. Does test set
TESTING
indicator light,
STOP
indicator go off, and
TIME
dis-
play start counting time?
If
YES,
then continue with Step
29.
If
NO,
then proceed to Step
34.
29. Allow test set to run for 15 minutes as shown on
TIME
display.
30. During 15-minute test period, does test set show
REPLACE
?
If
YES,
then continue with Step
31.
If
NO,
then proceed to Step
32.