DT Turn Up: DLP-506 363-205-401
Page 2 of 2 Issue 7, March 1997
9. On
PCU
faceplate, connect DMM test leads to
GND
jack and
BAT
jack.
10. Does DMM indicate between 13.8 and 15.0 volts?
If
YES,
then
STOP. YOU HAVE COMPLETED THIS PROCEDURE.
If
NO,
then continue with Step
11.
11. Inspect, repair, and/or replace the following items in the order listed until the
correct voltage reading is obtained:
•
PCU
• Wiring between battery pack and
PCU
• Battery pack.
To Next Page
Loading...