363-205-401 Power Up: DLP-503
Issue 7, March 1997 Page 5 of 10
16. Have all battery packs on shelf been replaced?
If
YES,
then proceed to Step
18.
If
NO,
then continue with Step
17.
17. Select another battery pack on battery shelf and repeat from Step
13.
18. Check battery lead connections at battery shelf. Repeat procedure from Step
9
after locating and correcting trouble.
19. Is another battery string to be installed at this time?
If
YES,
then proceed to Step
21.
If
NO,
then continue with Step
20.
20. Remove DMM test leads and proceed to Step
42.
21. Has battery string 2 been installed and tested?
If
YES,
then continue with Step
22.
If
NO,
then proceed to Step
4.
22.
!
DANGER:
High current flow will occur if short is placed across battery terminals. No
attempt should be made to measure battery voltage across terminals.
Get four KS-21906, L4 battery packs.
23. At front of battery shelf, remove front cover by lifting cover up and out (Figure
2).
To Next Page
Loading...
