Introduction
This document describes the Lucent 250-watt Telephone Paging Amplifier.These are
full-featured, wall-mounted amplifier that provides inputs for dry loop 600-ohm
telephone page signal, background music source, and low impedance microphone.A
set of control inputs allow an external contact closure to mute background music
and open the telephone page channel. Background music mute level during page is
adjustable and the music slowly fades back in after the page is completed. An
automatic level control system limits the output level of the telephone page channel
so that differences in the volume of the paging party's voice will be less noticeable.
Bass and treble controls are provided for adjusting the quality of the output signal.
An Aphex
® Aural Exciter feature is also provided. Aphex improves the clarity of the
output signal by replacing the higher frequency harmonics that are normally lost
through the telephone system.This amplifier includes a built-in night ringer that can
be triggered by either a standard telephone (analog) ring signal or an external
contact closure. The night ringer mutes the background music, but not pages.
Package Contents
* Telephone Paging Amplifier unit
* 4 wall-mounting screws
* Installation and Use Manual
Before You Start Review the contents of the box.Read through this entire manual to understand how
this product installs and operates.
NO
TE: Be sure you have enough 22 AWG shielded,twisted pair wire (COM Code:
401882956,PEC Code: 2734-SPK) for your speaker runs.
Telephone Paging Amplifier
Page 4 of 12
To Next Page
Loading...
Need help?
General