9
Say Goodbye to Ugly Products
STEP 4: CONNECTING THE FAN HEAD TO THE STAND POLE
1. Refer to diagram 4. Place the stand pole/base on a level surface.
2. Take the water hoses and electric wire from the fan head/pipe and thread
them through the top of the stand pole. Do not attach the fan head to the
stand pole yet.
3. Connect the male and female connector plugs together.
4. Take the small water hose from the fan head/metal pipe and connect it to
the other valve opening attached to the back panel.
5. Locate the large water hose from the fan head/metal pipe and connect it
to the large connector with the quick release valve.
6. Attach the fan head/metal pipe onto the stand pole and thread all hoses
and wires into the stand pole through hole B (elliptical shaped hole on the
stand pole). Make sure none of the hoses or wires are bent.
7. Reattach the screws onto the back panel.
8. Tighten the bolts located on the sleeve by the back panel to secure the
stand pole and fan head/pipe together.
To Next Page
Loading...