4. Wait about 20 seconds for the blade to stand still completely.
5. Remove the motor parking line (rip line) from the motor parking button.
5. Set the motor switch (1) to "OFF / OFF".
6. Insert parking brake (5).
7. Close the fuel tap (5).
The milling wheel is coupled by a centrifugal clutch and when the engine is
switched off, the wheel still runs out. The run-out time of the milling wheel
depends on the current engine speed.
Any re-braking of the milling wheel by hand or an aid is prohibited!
Maintenance
Regular maintenance of the root cutter guarantees a long service life, as well as all its parts.
Turn off the engine before all cleaning, maintenance and repair work, wait for the
milling wheel to stop and remove spark plug plugs.
When working in the area of knives, wear protective gloves!
Do not carry out maintenance work near an open fire. Fire!
Maintenance
1. Turn off the motor and allow to cool.
2. The throttle is located on "SLOW", in the idle position.
3. Always remove the spark plug. This prevents unintentional startup.
4. Inspect the general condition of the root cutter. The machine is exposed to vibrations during
working use. Therefore, after a few hours, all screw connections must always be checked for a
fixed seat.
5. Milling wheel and blades must be carefully maintained to avoid damage and injury.
6. Make sure the safe condition of the root cutter, in particular check the fuel system and the tank
cap for tightness.
To Next Page
Loading...