Lumag BSF15 - Troubleshooting, Warranty, and Support; Common Issues and Solutions

Troubleshooting
Before each fix
Switching off the machine
Waiting for the milling wheel to stop
Remove spark plug plugs
Disorder
Cause
Remedy
Motor cannot be started.
No fuel.
Fill the fuel tank.
starter defective.
Repair starters.
No engine oil.
Refill engine oil.
No spark.
Clean or replace the spark
plug.
Motor in cold condition and
choke set to OPEN (re)
Choke at position CLOSE
(left).
Fuel tap set to OFF.
Set the fuel tap to ON.
Motor is difficult to start or runs
poorly.
Incorrect fuel mixture.
Put choke in OPEN (re)
position.
carburetor set incorrectly.
hiring by specialist dealers.
Faulty spark plug, dirty or
set incorrectly.
Clean the spark plug, adjust
or replace new ones.
Engine gets too hot.
Too little engine oil.
Refill engine oil.
cooling air system.
Clean the fan grille, clean
internal cooling fins.
Air filter polluted.
Clean the air filter.
carburetor not set correctly.
carburetors are hired by
specialist dealers.
motor not enough power.
Air filter polluted.
Clean the filter elements,
replace them if necessary.
Machine is clogged.
Clean the machine
thoroughly from the inside.
The milling wheel does not rotate.
The motor speed is not
sufficient to trigger the
centrifugal clutch.
Check the gas rope for
proper function.