The milling wheel continues to
rotate.
attached or damaged.
proper function.
damaged and does not
uncouple properly.
Change the coupling.
The parking brake slips. Brake pressure is too low.
Check the brake rope and
brake lever for damage.
Check brake pads for wear.
Excessive vibration.
blades, screws, nuts or other
parts loose.
immediately! Check all nuts
and screws for a fixed seat,
replace damaged parts,
adjust V-belt tension.
If these measures do not correct the error or if errors occur that are not mentioned here, then have
your machine checked by a specialist.
Ensure
The device is given the statutory warranty period. Any defects that can be proven to be due to
material or assembly defects must be reported to the seller immediately. Proof of the purchase of
the device must be provided upon use of the warranty by presenting the invoice and receipt.
The warranty is excluded with regard to the parts, if defects due to natural wear, temperature,
weather conditions as well as due to defects due to negligent assembly, defective connection,
incorrect fuel/fuel mix, installation, operation, maintenance, lubrication or force.
Furthermore, for damages caused by unsuitable misuse of the machine, such as improper
modifications or self-responsible repair work of the owner or third parties, but also in case of
intentional overloading of the machine, no warranty.
Wear parts with a limited service life (e.g. V-belts, clutch, gas cable pull, spark plug, air filter,
battery, blades, hoses, wheels, tools and other aids) as well as all adjustment and adjustment work
are excluded from the warranty.
To Next Page
Loading...