LUMBERJACK TOOLS PRO Series - Troubleshooting

AssemblyPartsIncluded:





BladeAssembly/Setting

1. Inserttheallenwrench(included)intothecapscrewandtighten
thescrew


2. Makesurethebladegapsettingisthesamedistanceapartforboth
blades(about1/8”1/4”)Seebelow

3. Youcanslightlychangethetenondiameterbyslidingthebladeinor
out.Slidingitinwillreducethediameter,andslidingitbackwill
increasethediameter.DONOTslideitbeyond¼”fromthefaceof
thecutout.Doingsowillnotcutatenon,astheblademustbe
exposed
 


4. Ifthebitistooaggressiveorstopsyourdrillwhilecutting,youcan
removeonebladefromthetoolandoperateitwithoneblade

Securelytightenthecapscrew,buttakecautionnottostripit(donotover
tighten).Recheckbothscrewsbeforestarting
Troubleshooting

TOOLSKIPSOFFTOONESIDEORBOUNCESAROUND
• Logislargerthanwhatthetoolwillaccept
• Notenoughbodypressureisbeingapplied
• Drillrunningpriortopositioningtothelog.Youmusthavethe
drillpositionedagainstthelog,applybodypressure,thenstart
thedrill

NOTCUTTING
• Bladesareslidbacktoofar–notgrabbing
• Notapplyingenoughbodypressure
• Bladesaredull

TAKESTOOMUCHOFA“BITE”
• Removeonebladeor“shim”upnomorethan.020”

DRILLSTOPSORCUTSONSMALLDIAMETERLOGSBUTNOTLARGERONES
• Thisiscausedbyusingavariablespeeddrill
• ToohighofRPM
• ThismayalsobecausedbyusinganonMilwaukeebranddrill
o DeWalt,Makita,Rigid,etchavelesstorquethan
Milwaukee

CROCKEDJOINT
• Thisisfromholdingthedrillcrockedtothelog

SPIRALGROOVESONTHETENONJOINT
• Thisiscausedbywobblingthedrillsidetosidewhilecutting
OR
• Removingthecutterfromthelogwhilethedrillisstillspinning




AllenWrench
CapScrews
Blades
RIGHT
RIGHT
WRONG
1/8”
1/4”
8