LUMBERJACK TOOLS PRO Series

Questions and Answers

V
villanuevarebeccaJul 29, 2025
What to do if the LUMBERJACK TOOLS PRO Cutter is not cutting log?
- E
  Elizabeth MontesJul 29, 2025
  If your LUMBERJACK TOOLS Cutter isn't cutting the log, there could be several reasons: * The log might be larger than the tool can handle; in this case, taper down the end of the log with a draw knife. * The blades might be dull, so try sharpening them. * You might not be applying enough pressure; try leaning into the drill with your body. * Consider purchasing new blades.
F
Francisco SandersAug 3, 2025
Why does my LUMBERJACK TOOLS PRO Cutter tool skip off to one side or bounce around?
- R
  Robert SanchezAug 3, 2025
  If your LUMBERJACK TOOLS Cutter is skipping or bouncing, it could be due to a couple of reasons. First, the log may be larger than what the tool is designed to handle; try tapering down the end of the log using a draw knife. Second, you might not be applying enough pressure; try leaning into the drill with your body to apply more force.
L
lthompsonAug 8, 2025
What to do if my LUMBERJACK TOOLS PRO drill stops or cuts on small diameter logs but not larger ones?
- D
  David JohnsonAug 8, 2025
  If your LUMBERJACK TOOLS Cutter drill stops or struggles with larger logs, it might be because you're using a variable speed drill or one that isn't powerful enough. It's strongly recommended to use a single-speed drill with low RPM and high torque for optimal performance.
P
Pamela ParkerAug 13, 2025
How to prevent spiral grooves on the tenon joint when using the LUMBERJACK TOOLS PRO Cutter?
- S
  Shawn SmithAug 13, 2025
  To avoid spiral grooves on the tenon joint when using the LUMBERJACK TOOLS Cutter: * Hold the drill steady while cutting to prevent lateral wobbling. * Do not remove the cutter until the drill has come to a complete stop.
D
Daniel GoodmanAug 18, 2025
What causes a crooked joint with the LUMBERJACK TOOLS PRO Cutter, and how to fix it?
- J
  Jennifer RobinsonAug 18, 2025
  A crooked joint with the LUMBERJACK TOOLS Cutter is often caused by holding the drill crooked while cutting. To fix this, make sure to position the drill square against the log before you start cutting.
C
curtissmithAug 23, 2025
Why LUMBERJACK TOOLS Cutter takes too much of a "bite"?
- H
  Heather JacksonAug 23, 2025
  The LUMBERJACK TOOLS Cutter taking too much of a "bite" is due to aggressive cutting from the dual blades. You can remove one blade or "shim" blade up to .020" to resolve this.