9
Motor Mount Adapter
● If desired the ST2000 can be
mounted to a motor for
production stake cutting
● We offer an adapter that allows the tool to
fit over a motor shaft. The Motor Shaft
Adapter is available for purchase on our
website or by phone
● Remove the shank that comes pre-installed to the
tool by using a pipe wrench
● Screw the adapter into the tool where the shank
was removed
● Slide the tool with the adapter over the motor
shaft and secure in place by tightening the set
screws
● NEVER exceed more than 1750 RPM when
operating the tool
● If you have any questions or would like to know
more information customer service is always glad
to help!
To Next Page
Loading...