EasyManua.ls Logo

Lumex LF2020 Easy Lift STS - Maintenance Schedule

Lumex LF2020 Easy Lift STS
20 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
LF2020-INS-LAB-RevG18
14
MAINTENANCE SCHEDULE
Info: Only qualied persons should service and repair your Lumex LF2020 Easy Lift STS /
LF2090 Bariatric Easy Lift STS. Regular maintenance of your patient lift is necessary to
ensure continuing proper and safe operation. Read and observe the following recommended
maintenance schedule:
Item Inspect
initially
Inspect / Adjust
daily monthly every 6
months
Base, Casters, and Foot Paddle
Ensure that base is level (all four wheels touch the oor) x x x
Ensure that bolts and nuts are tight x x x
Ensure that casters swivel and roll freely x x x
Apply White Lithium Grease to caster ball bearings x
Check rubber parts of casters for deection x x
Check welding joints for rust and cracks x
Ensure that base opens and closes smoothly x x x x
Ensure that base locks securely in three positions x x x
Ensure that base locking knob is in place and operating properly x x x
Inspect all base hardware for wear x
Mast
Ensure that mast is fully engaged and locked into mast sleeve x x
Inspect mast for bends or deections x
Inspect all mast hardware for wear x x
Boom
Inspect boom for bends or deections x x
Ensure that boom is centered between the base legs x x x
Inspect all boom hardware for wear x
Inspect sling hooks for wear or deections x x
Check connections between boom and mast for improper
connection, looseness, or wear
x x
Slings and Sling Hardware
Check slings and straps for wear and damage; discard if worn x x
Inspect metal/plastic parts for wear or damage x x
Lubrication with White Lithium Grease
Lubricate all pivot points x
Lubricate top and bottom of actuator mounting x
Cleaning
Clean with mild non-abrasive detergent x
Actuator and Electronics
Ensure that batteries are charged x x
Inspect for proper up / down operation x x
Ensure that mounting hardware is tight x x
Inspect mounting hardware for wear x
Ensure that control box is rmly afxed to the mast x x
Ensure that the actuator connecting cable is tight x x

Related product manuals