What to do if my Lumex Mobility Aid cannot lift patient and battery indicator shows no GREEN light?
If your Lumex Mobility Aid cannot lift the patient and the battery indicator shows no green light, the batteries are likely discharged. You should charge the batteries.
Why is the control box not responding on my Lumex Mobility Aid?
If the control box of your Lumex Mobility Aid isn't responding and the relay isn't clicking, the batteries might be discharged, requiring a charge. Alternatively, the battery charger itself or the batteries could be defective and need replacement. It's also possible the hand control is defective, in which case it should be replaced.
What to do if the actuator does not run, but relay is clicking on Lumex Mobility Aid?
If the actuator on your Lumex Mobility Aid doesn't run, but the relay clicks, ensure the actuator plug is firmly pushed into the control box. If it still doesn't work, the actuator or the control box might be defective and require replacement.
What to do if Lumex Mobility Aid lift does not work and the battery indicator shows no light?
If your Lumex Mobility Aid lift isn't working and the battery indicator shows no light, ensure the emergency stop button is released. Also, check the connection of the batteries in the control box.
What to do if Battery Indicator shows no light when charger is connected to power supply for Lumex LF2020 Mobility Aid?
If the battery indicator shows no light when the charger is connected to the power supply for your Lumex Mobility Aid, verify that the emergency stop button is released. Also, inspect the charger plug and cable for any signs of damage.
What to do if Lumex Mobility Aid lift does not work and the battery indicator shows full charge?
If your Lumex Mobility Aid lift isn't working despite the battery indicator showing a full charge, check the connection between the actuator and the control box. Also, verify the connection between the pendant and the control box.
Why does the actuator only go up or down on my Lumex LF2020?
If the actuator on your Lumex Mobility Aid only goes up or down, but not both, the hand control or the control box may be defective, requiring replacement.
Why Lumex LF2020 Mobility Aid stop-and-run while lifting or lowering patient?
If your Lumex Mobility Aid stops and starts intermittently while lifting or lowering a patient, check the socket for the pendant plug-in. Also, inspect the pendant cable for any damage.
What does it mean if Lumex Mobility Aid lift does not work but battery indicator shows full charge and there is a click sound?
If your Lumex Mobility Aid lift does not work, the battery indicator shows full charge, and you notice a “click” sound from the control box when the UP or DOWN button on the hand control is pressed, this indicates an actuator problem.
Emphasizes reading and understanding the manual before use to prevent injury or damage.
Covers warnings on shipping damage, tipping, and patient suitability for the lift.
Instructions for unpacking, inspection, and proper storage of the patient lift.
Detailed steps and important notes on correctly fitting the Lumex Sit-to-Stand sling.
Explains the meaning of different buzzer types and their indications for lift status.
Details pre-use checks, lubrication points, cleaning, and inspection for wear and damage.
Proper washing and drying guidelines for Lumex slings, including a no-bleach warning.
General| Type | Rollator Walker |
|---|---|
| Width | 24.5 inches |
| Frame Material | Aluminum |
| Foldable | Yes |
| Weight Capacity | 300 lbs |
| Seat Width | 18 inches |
| Seat Material | Padded |
| Seat Depth | 33 cm (13 inches) |
| Wheel Size | 20 cm (8 inches) |
To Next Page
