Lumos Kickstart - Strap and Fit Adjustment; Care Instructions; Cleaning and Maintenance; Impact and Replacement

3) Adjust the strap tension at the buckle so that the helmet is strapped snugly.
Tighten the strap as required to obtain a snug t. With the helmet on and tightly
fastened, make sure the helmet cannot be removed from your head or rolled back-
ward or forward excessively. Be sure that the buckle is not against the jawbone.
4) When properly tted and adjusted, your ears should not be covered by any part
of the straps.
5) Make sure you can see clearly and your peripheral vision is not blocked.
To check for proper tension, put on the helmet and fasten the buckle. Open your
mouth. You should feel the strap pulling against your chin. Then attempt to pull
the helmet o the front or rear. If the helmet comes o, increase strap tension and
examine if thick enough pads are being used. The helmet should not be able to roll
forward or backward excessively. It should not be possible to remove the helmet
without unfastening the buckle.
NOTE: Please check adjustment every time this is helmet is worn.
CARE INSTRUCTIONS
1) For cleaning, use a soft cloth, mild soap, and water only. Your t pads are remov-
able and should be washed by hand with mild soap and water, rinsed and then
air dried only. The protection given by this helmet may be severely reduced by the
application of paint, adhesive stickers and transfers, cleaning uids, chemicals, pe-
troleum and petroleum products, and other solvents. The helmet will be damaged
if exposed to temperatures exceeding 62˚C (150˚F). Never remove or modify the
original elements that constitute the helmet, or add accessories not recommended
by the manufacturer, as it may risk canceling the protective role of the helmet.
During transportation, do not expose your helmet to impact or external force.
Store in a dry place, away from heat from, for example, a radiator or direct sunlight
through a car window.
2) Replacement: This helmet is designed to absorb shock through partial destruc-
tion of the energy absorbing liner. This damage may or may not be visible to the
user. After a severe impact or blow, deep scratches or other abuse, this helmet
should be destroyed and replaced even if it appears undamaged. A helmet should
also be replaced after a few years of careful use and if it does not t anymore.
Operating and charging temperature:0-45C;