Need help?Do you have a question about the Luna BDS 300 and is the answer not in the manual?
General warning symbol indicating potential hazards.
Warning for rotating objects, indicating a potential hazard.
Warning for electrical hazards, indicating danger from electricity.
Warning for rotating cutting tools, indicating a hazard.
Warning symbol for saw blades, indicating a sharp hazard.
Warning to switch off power supply during service and maintenance.
Warning symbol for saw blades, indicating a sharp hazard.
Symbol indicating the need to read the instruction manual.
Symbol requiring the use of protective eyewear.
Symbol indicating the requirement for hearing protection.
Symbol indicating the need for a protective mask.
Symbol indicating the requirement for protective gloves.
Symbol indicating the need for protective footwear.
Symbol indicating the method for lifting with a hoist.
Prohibition symbol against wearing jewelry during operation.
Prohibition symbol against wearing gloves during operation.
Warning to avoid wet hands when operating the machine.
Warning against standing on tools to prevent injury from tipping or contact.
Safety rule to disconnect tools before any maintenance or accessory changes.
Instruction to check for damaged parts to ensure proper operation and safety.
Importance of maintaining a clean work area to prevent accidents.
Safety measure to keep visitors at a distance from running machines.
Recommendation to childproof the workshop for safety.
Prohibition against operating tools under the influence of drugs, medication, or alcohol.
Advice on wearing appropriate clothing, avoiding loose items and jewelry.
Requirement to wear safety glasses and hearing protection during operation.
Emphasizes reading all instructions before operating.
Ensure the machine is completely assembled before operation.
Do not operate if any parts are missing.
Obtain assistance from a qualified person if unfamiliar with operation.
Recommend firmly mounting the machine to a secure work surface.
Prioritize wearing protective eyewear before operating.
Do not operate under the influence of drugs or alcohol.
Remove all jewelry prior to operating the machine.
Do not wear any gloves while operating this machine.
Ensure the power switch is OFF before plugging in the machine.
Ensure the power switch is OFF when doing assembly or setup.
Use a dust mask, dust collection, and proper ventilation.
Use only recommended accessories to avoid injury or damage.
The machine must be properly grounded for safety.
Use abrasive discs of the recommended diameter.
Keep face and hands clear of moving parts like belts and pulleys.
Keep power supply cords free of moving parts to prevent damage.
Maintain a 1/16" clearance between the sanding disc and table.
Always support the workpiece with the table.
Remove debris and keep the work area neat and clean.
Keep these instructions for future reference.
Instructions for securely attaching the sander base to a workbench.
Details on aligning and securing the sander base using screws.
How to loosen and tighten the lock knob for table positioning.
Adjusting the table to be square to the sanding disc.
Adjusting table position for optimal 1/16" clearance from disc.
Warning against applying the disc brake with the switch in the ON position.
How to apply the manual disc brake using the brake lever.
Instructions for tilting the worktable for bevel sanding.
Maintaining table-disc clearance during bevel sanding.
Recommendation to use a miter gauge for this operation.
Moving work across the left side of the sanding disc is advised.
Warning about workpiece kickback when applying to the right side of the disc.
Possible causes and solutions for the sander failing to start.
Causes and solutions for the disc not reaching proper speed.
Reasons for excessive machine vibration and how to fix it.
How to ensure the sanded edge is square to the disc.
Causes and solutions for sanding marks on wood.
To Next Page
General
