Need help?Do you have a question about the Luna BBD 150 and is the answer not in the manual?
General symbol indicating a potential hazard.
Symbol indicating hazard from rotating machinery parts.
Symbol warning of electrical shock hazard.
Symbol for hazard associated with rotating cutting tools.
Symbol warning about hazards related to saw blades.
Instruction to disconnect power before servicing the machine.
Repeated warning symbol for saw blade hazards.
Sign requiring user to consult the instruction manual.
Sign mandating the use of eye protection.
Sign requiring the use of hearing protection.
Sign mandating the use of a protective face mask.
Sign requiring the wearing of protective gloves.
Sign mandating the use of safety footwear.
Instruction to use lifting equipment for heavy items.
Prohibition of wearing jewelry while operating machinery.
Prohibition of wearing gloves when operating the machine.
Warning against operating the machine with wet hands.
Understand the tool's operation, limitations, and specific hazards.
Ensure all safety guards are correctly fitted and functional.
Verify that all electrical tools are properly grounded.
Always remove tools used for adjustment before power-on.
Perform a thorough check of the sander for damage and proper function.
Follow safe practices to prevent accidents during operation.
Take precautions and wear appropriate PPE for safety.
Strategize your work to ensure safe and efficient operation.
List of necessary tools for unpacking the machine and its parts.
Instructions for securely attaching the sander to a stable work surface.
Procedure for correctly fitting the sanding disc and its protective guard.
Steps required to install the work table component for belt sanding.
Steps to precisely align the work table perpendicular to the disc.
Guide for fitting, setting tension, and aligning the sanding belt.
Explanation of the no-volt switch function and emergency stop feature.
Crucial pre-operation checks and manual review steps.
Daily or pre-operation inspection checklist for the sander.
Instructions for performing bevel cuts using the adjustable work table.
Method for adjusting the belt bed to horizontal or vertical orientations.
Technique for sanding convex and concave curves on the idler drum.
Process for performing flat surface sanding using the belt.
Method for sanding the ends of workpieces on the sanding belt.
Technique for sanding small end surfaces on the disc.
Guidance on the lubrication needs of the machine's bearings.
Step-by-step instructions for replacing the timing belt.
A comprehensive guide to diagnosing and resolving common machine issues.
Electrical diagram illustrating the No-Volt Release switch functionality.
To Next Page
General
