Why did my Lunix Massager suddenly stop working?
Your Lunix massager may have stopped working because it automatically shuts off after 15 minutes of use, or there was a power outage. Allow the unit to cool down before using it again.
Why is the Lunix LX3 pressure too low?
If the massage pressure on your Lunix massager feels too low, it could be due to a low battery. Try recharging the unit. Alternatively, the intensity level might be set too low; in that case, increase the intensity level.
What to do if Lunix Massager pressure is too strong?
If the massage pressure on your Lunix massager feels too strong, the intensity level may be too high. Try using the I1 Intensity setting. Also, ensure your hands are correctly positioned inside the unit; adjust them for a comfortable fit.
Why are the airbags not inflating on my Lunix Massager?
If the airbags on your Lunix massager aren't inflating, the battery may be low. Recharge the unit.
Why is the heat function not working on my Lunix massager?
If the heat function on your Lunix massager isn't working, the unit might not be fully charged. Also, it takes 10-12 minutes to achieve the highest temperature. Wearing thin gloves can help increase the feeling of heat.
Why is my Lunix LX3 Massager hot?
If your Lunix massager is hot, it may be due to excessive use. Power off the unit and let it cool down before using it again.
Why is the air pump not working on the wrist area of my Lunix LX3 Massager?
If the air pump isn't working on the wrist area of your Lunix massager, you might have the wrong program selected. Try the wrist program.
Why do I hear a faint sound while using the Lunix LX3 Massager?
A faint sound during use of the Lunix massager is normal behavior.
Why is the red light not flashing while charging my Lunix massager?
If you cannot see the red light flashing while charging your Lunix massager, the unit may not be charging properly. Ensure the USB cable fits securely between the USB port and cable. Also, make sure the plug does not exceed 5V 2A.
Why do I have dimples on my hand after using the Lunix massager?
Dimples on the hand after using the Lunix massager are normal and should disappear after 30 minutes.
Details compliance with Class B digital device rules and potential interference.
Explains intensity level adjustment and program mode selection buttons.
Details vibration mode selection and heat function activation buttons.
Covers the power button and automatic session shut-off feature.
Guides on how to charge the massager before first use, including charging times.
Advises consulting a doctor for specific medical conditions before use.
Covers battery handling, charging risks, fire hazards, and supervision for children.
Explains the 6 available program modes and how to select them.
Details how to turn the heat function on/off and its benefits.
Describes the two vibration modes (pulse and continuous) and how to switch.
Provides guidance on storing, cleaning, and maintaining the massager.
To Next Page
General
