Luowei OILFREE COMPRESSOR User Manual

OPERATION MANUAL
OILFREE COMPRESSOR
CAUTION:
Before using this product, read this manual first.
INSTALLATION & ASSEMBLY
WARNING
The air compressor should be turned off and unplugged from the power source
before any installation and assembly is performed as well as the air bled from
the tank and the unit allowed time to cool. Personal injuries could occur from
moving parts, electrical sources, compressed air or hot surfaces.
To Install the Air Intake Filter
Remove the assembly from the poly bag and thread the filter assembly onto
the head of the compressor.
Installing wheels
Install one shoulder bolt, washer, and one nut for each wheel using bolt holes
provided in the wheel bracket. The shoulder bolt will install from the outside of
the wheel through the top hole in the wheel bracket. Tighten securely with the
washer and nut position on the inside of the wheel bracket.
WARNING
The wheels and handle do not provide adequate clearance, stability or support
for pulling the unit up and down stairs or steps. The unit must be lifted or push
up a ramp.
CAUTION
It may be necessary to brace or support one end of the air compressor when
attaching the wheels, because it will have a tendency to tip.
Lubrication and Oil
This compressor requires no lubrication or oiling. No break in procedure is
required by the user. This product is factory tested to ensure proper operation
and performance.

Luowei OILFREE COMPRESSOR Specifications

General

Brand	Luowei
Model	OILFREE COMPRESSOR
Category	Air Compressor
Language	English

Summary

INSTALLATION & ASSEMBLY

Safety Precautions

General safety warnings and cautions for installation tasks, covering power, parts, and handling.

HOW TO SET UP YOUR UNIT

Electrical Circuit Protection

Requirements for voltage supply and circuit protection, including amp limits.

OPERATION

Controls and Components Overview

Explanation of the On/Auto/Off switch, pressure switch, gauges, and regulator.

START-UP AND BREAK-IN PROCEDURES

Break-in Period Instructions

Pressure Rating Warning

HOW TO START AND MAINTENANCE

Starting the Compressor

SAFETY VALVE AND DRAIN TANK

Checking the Safety Valve

Tank Draining Warning

AIR FILTER SERVICE AND GENERAL REPAIRS

General Service and Repair Warning

Pre-Servicing Safety Steps

Essential safety measures before performing maintenance: unplug, bleed pressure, cool unit.

STORAGE AND TROUBLESHOOTING

Storage Warning

Troubleshooting Introduction

General safety warning before attempting any problem correction or task.

TROUBLESHOOTING GUIDE

Air Leaks

Identifies causes and corrections for air leaks from the check valve or safety valve.

Pressure Issues

Addresses problems like regulator pressure drops and excessive tank pressure.

Motor and Moisture Problems

Solutions for motor start issues, excessive moisture, and tank leaks.