Lupine SLX User Manual

Avoid looking directly into the light. Close your eyes and move head if light shines into eyes. Do not use focusing optical devices.

Housing may heat up. Keep light away from combustible materials. Could cause fire or death. Quiescent operation is possible.

SL components are waterproof, comply with IP68. Not a diving lamp, not suitable for use under water.

Do not use a strong water jet or heavy detergent to clean the lamp.

Step-by-step instructions for attaching the lamp to the handlebars, including bolt and clamp assembly.

Guidance on positioning and aiming the lamp for optimal illumination distance and height.

Explains how to turn on the remote, its status lights (no light, green, blue), and brightness sensor modes.

Sets the light to ECO mode, offering high beam (18W) and low beam (6.5W) options.

Configures delay for sensor-controlled switchover and calibrates the brightness sensor.

Allows manual beam switching and resetting the light to factory settings.

Identifies common errors like light not turning on or switching beams, and provides solutions.

Details on operation, lamp system, dimensions, material, protection class, and approvals.

Specifies mounting restrictions for pedal-assisted bicycles with DC power supply and specific control units.

Outlines requirements for replacing defective light sources (LEDs) and directs repair to Lupine.