LUTEC 6940004012 - Safety Information

No
Note: Batteries may have become depleted due to lack of sunlight for an extended
period causing the bulbs to not illuminate. Please place the solar head in direct
sunlight for at least 6 hours prior to assembly.
te: Charging conditions differ by time zone locations and affects total hours of light discharge.
3
PART
DESCRIPTION
QUANTITY
A
Lampshade
2
A1
Diffuser
2
A2 Battery-Replacement model # 182107526 2
A3 Bulb-Replacement Model # 170200150 2
A4 Battery Cover 2
A5 Battery Cover Screw 2
B Elbow Components 1
B1
Set Screw 1
1
C
Top Pole
1
C1
Set Screw 2
1
D
1/8 in Allen Wrench
1
E Middle Pole 1
F Base 1
F1 Base Screws 3
G 13/32 in Cap Nuts 3
H 13/32 in Washers 3
I
Concrete Mounting Bracket
1
stloB rohcnA J 3
K
Ground Base Insert
1
L
8 5/16 in Small Ground Stakes
3
M 17 1/2 in Large Ground Stake 1
N Turn Rod 1
stuNni 23/31 O 3
P 3
Q 3
SAFETY INFORMATION
Please read and understand this entire manual before attempting to assemble, operate or install
the product.
The solar panel “Post Light” requires sunlight to charge the batteries and should be installed in an
WARNING:
13/32 x 2 3/16 in Hex Bolts
3/16 x 7/8 in Ground Stake Screws
area with a minimum of 8 hours of direct sun exposure.
R 1Glue