122
by Lutron
1
Tap the "Shade" button quickly at least three times, holding on the last press.
3
Release the "Shade" button, then immediately tap the button at least three more times and release.
2
Continue to hold the "Shade" button until the button LED flashes green.
HOLD
NOTE: This procedure will remove all paired Pico remote controls and favorite button programming. Upper and lower limits are retained.
NOTE: The "Shade" button LED will flash GREEN-then-RED three times, signaling the successful completion of the procedure.
3x
Removing Paired Pico Remote Controls from a Lutron Honeycomb Shade
TAP 3x
TAP 3x
To Next Page
Loading...