83
by Lutron
Multi-Location Installation - Caséta Wireless ELV+ Dimmer with Pico Remote Controls (PD-5NE)
Multi-Location Installation - Caséta Wireless Fan Control with Pico Remote Controls (PD-FSQN)
1
Identify existing wiring
2
What you need for a multi-location installation
WARNING! Shock Hazard. May result in Serious
Injury or Death. Turn off power at circuit breaker
before installing the unit.
4
Turn power off at circuit breaker
5
Remove existing switch from wall at Location 1
- If one switch controls the fan (single-pole installation)
See quick-start guide that came with your fan control
- If two switches control the fan (3-way installation)
See page 23 for details
Important note:
3
Choose a location for your Caséta Wireless fan control
NOTE: There will be two different types of existing switches in this
application. Locations 1 and 3 will use 3-way switches (three screws
which control the fan, plus one ground screw) and Location 2 will use a
4-way switch (four screws which control the fan, plus one ground screw).
For easiest installation, we recommend replacing one of the 3-way
switches with your fan control (Locations 1 or 3). In this example, we will
use Location 1.
Location 1
3-Way Switch
(Locations 1 and 3)
4-Way Switch
(Location 2)
Three or more switches control the fan
(multi-location installation)
Location 1
Location 2
To Fan
Location 3
+
+
Fan control
PD-FSQN
Two Pico wallbox
adapters
PICO-WBX-ADAPT
+
Three Claro wallplates
CW-1
Two Pico remote controls
for fans
PJ2-3BRL-XXX-F01
To Next Page
Loading...