135
by Lutron
Motion Sensor Placement Examples (continued)
10
Staircase
A Caséta Wireless motion sensor is mounted flat on the ceiling, perpendicular to the staircase. If there is a railing present (or one side of
staircase is open to an adjacent area as shown below), align the top of the sensor with the railing (or edge of adjacent area), and the bottom
of the sensor facing the wall, so the sensor only "sees" the staircase and not the adjacent area. The sensor and Pico remote control with
wallplate are paired to a Caséta Wireless switch that controls the light in the staircase. The Auto-On setting is set to "Enabled", allowing for
the sensor to automatically turn the light On / Off when a person enters / exits the staircase.
Adjacent
Room
Caséta Wireless
Switch
Top of Flat Wall-Mount
Caséta Wireless Motion
Sensor
Pico
Remote
Control
Hand Rail
Pico Remote
Control
Back of Flat Wall-Mount
Caséta Wireless Motion
Sensor
Caséta Wireless
Switch
Hand Rail
Adjacent
Room
Side View Top View
Motion Sensor Placement and Coverage (PD-OSENS / PD-VSENS)
9
Hallway
A Caséta Wireless motion sensor is mounted flat on the wall near the Caséta Wireless switch at the height of 6 ft (1.8 m) where it can "see"
the whole hallway. The sensor may see movement in the rooms if the doors are open. Adjusting sensor location may be necessary based
on layout. The sensor is paired to Caséta Wireless switch. The Auto-On setting is set to "Enabled", allowing for the sensor to automatically
turn the light On / Off when a person enters / exits the hallway.
Room
Entry
Caséta Wireless
Switch
Flat Wall-Mount Caséta
Wireless Motion Sensor
Room
Entry
Room
Entry
Room
Entry
To Next Page
Loading...
