48
by Lutron
8
Connect the new Caséta Claro Smart switch
Tagged Wire
Note wire color
tied to blue wire
Ground
(Green Wire)
White
11
Remove existing toggle switch from wall at Location 2
3-Way Installation - Caséta Claro Smart Switch with Mechanical Toggle Switch (DVRF-5NS)
12a
Modify wiring for existing toggle switch
Ground - Green / Bare Copper
(keep connected to switch)
Different Color
Screw / Tagged Wire
(disconnect from switch)
Noted wire color
from Step 8
(keep connected to switch)
Location 2
Location 2
Location 1
Red
Blue
Black
Neutral
connection
required
1
Neutral required.
2
The maximum lamp wattage is determined by the efficiency of the transformer, with
70% – 85% as typical. For actual transformer efficiency, contact either the fixture or
transformer manufacturer. The total VA rating of the transformer(s) shall not exceed the VA
rating of the switch.
3
The switch is ULR Listed for use with all magnetic and electronic fluorescent ballasts.
Remaining Wire
(disconnect from switch)
7
Ganging and derating
9
Mount the Caséta Claro Smart switch
10
Attach the wallplate
Important note:
Ganging units together may reduce the switch’s maximum wattage
rating. See the chart below for maximum wattage information.
DVRF-5NS (120 V~)
1
LED 5 A 5 A 5 A
Halogen / incandescent 600 W 600 W 600 W
Electronic Low-Voltage 600 VA 600 VA 600 VA
Magnetic Low-Voltage
2
600 VA 600 VA 600 VA
Fluorescent
3
5 A 5 A 5 A
General Purpose Fan 3 A 3 A 3 A
Note: Claro Smart controls don’t have fins but derating is
still required. See the chart below.
‘snap’
Wallplate
Adapter
Wallplate
Location 1
B
B B
C
B
A
To Next Page
Loading...
