Application Note #734
14 www.lutron.com/support
Restore Factory Default Settings
The dimmer can be returned to its original factory settings. This allows the customer a risk-free experience to try
multiple settings.
1. Triple tap the
Off
button rapidly, holding on the last press.
2. Continue holding until the light bar and the lighting load begin to raise from low to high in about 3 seconds.
3. Immediately triple tap the
Off
button again and release.
4. The light bar and lighting load will begin to raise from low to high 3 times, the middle of the light bar flashes, the lights turn
off and then turn back on to high-end.
Default Settings
Feature Default
High-end trim Highest level of trim range
Low-end trim Middle level of trim range
Light level indicator / Locator light ON /ON
Light bar brightness Medium brightness
Preset light level
Tapping the
On
button always sets the
lights to full (locked preset at high-end)
1.
TAP 3x
(in <1 sec)
HOLD
(~3 sec)
UNTIL
2.
LOW TO HIGH
3.
TAP 3x
(in <1 sec)
AND
System Features (HRST- and RRST- Models Only)
Note: If setting up as part of a system, phase settings and low-end trim levels made on the dimmer will be over-written by
the system software.
RRST-PRO-N - For use in a RadioRA 3 system, please refer to the Getting Started Guide: www.lutron.com/RA3support
Some dimmer behavior features can only be adjusted through the Lutron Designer software.
1. Fade ON/OFF rate: The rate at which the load turns ON or OFF from its previous state.
2. Delayed Long Fade-to-Off (DLFTO) Time: Allows for control over how quickly / slowly the load begins the start of the
dimming sequence. This setting delays the time between when the
Off
button is pressed (normal operation) and when the
lights actually begin the fade-to-off process.
To Next Page
Loading...
