6
EN
0698-819 B28, B36/ MI 4, B55T / MAII - 04/18
• Ensurethat allwork is carriedout by qualied
personnel only:
- Assembly, servicing, maintenance work
- Work on the electrics
• Personnel to be trained must only work on the motor
under the supervision of technical personnel.
• Personnel holding the motor in their hands during
operation will be subjected to vibrations. The upper
limbs are exposed to an acceleration of less than
8.2 ft/s² (2,5 m/s²).
Statutory warranty
• During the guarantee period, obtain the manufac-
turer'spermissionformodications,maintenance
work or alteration.
• Use only original parts.
Duties of the personnel
• Observe the notices on the motor and maintain them
in a legible state.
• Useprotectiveequipmentwherenecessary.
• Only perform work on the motor during downtime.
• Ensure that the motor is disconnected before you
carry out assembly and maintenance work.
• After completing all the work on the motor, remount
thesafetydevicesinaccordancewithspecications.
2.2 Proper use
• The motor may only be installed in an upright
position.
• Observe operating limits.
• The motor may only be operated with a pump tube.
If the product and supplied accessories are used for
other purposes than the intended purpose, it is the
responsibility of the user to check the suitability and
admissibility.Productusenotconrmedinwritingby
the manufacturer absolves the manufacturer of any
liability.
Themanufacturer is notliable forconsequences of
incorrect treatment, use, maintenance, servicing and
operation of the appliance, as well as normal wear and
tear.Thesameappliesiffaultsarisefrommodications
orcongurationsonthepartoftheusernotauthorized
by the manufacturer.
Prevention of obvious misapplication
(examples)
• Do not use the motor in or on swimming pools,
garden ponds or similar locations.
• Donot immerse the motor inthe liquidbeing
pumped.
• Donotuseforpumpingammableliquids.
• Do not operate the motor in explosion hazard area.
To Next Page
Loading...
Need help?
General
