LuxaFlex PowerView Motorisation Guide

IMPORTANT: Is this your first remote? If so, continue
reading for programming steps. If you have already installed
a PowerView Hub or additional remotes, refer to page 17 for
more information.
A GROUP can be a single window covering or multiple
window coverings. There are six unique assignable
GROUPS to use on each remote. A window covering may
be assigned to more than one GROUP.
NOTE: It is recommended that only similar window
coverings be included in a GROUP because of differences
in product features and operation. When a window
covering is added to a GROUP for the first time, it is also
added to the PowerView Shade Network that links window
coverings and devices together.
Join a window covering to a GROUP
1. Press and hold STOP for 4 seconds to put the
remote in program mode. The backlit buttons on the
remote will flash to indicate it is in program mode.
2. Press the desired GROUP number (1– 6) on the remote.
The backlit GROUP number will flash to show it is
selected.
3. Press and hold the manual control button on the
window covering.
4. While continuing to press the manual button, press
OPEN on the remote. The window covering will
move slightly to indicate it has been joined to the
GROUP. Release the manual control button.
5. Press and hold STOP for 4 seconds to exit program
mode. The lights will stop flashing.
12
PROGRAMMING

LuxaFlex PowerView Motorisation Specifications

General

Brand	LuxaFlex
Model	PowerView Motorisation
Category	Remote Control
Language	English