19
What’s the Difference?
Paired remote Cloned remote
Same PowerView
Shade
Network I.D. as original remote.
Same PowerView Shade
Network I.D. as original
remote.
Can be programmed differently
from original remote.
An exact duplicate of
original remote.
Can control a different set of
window coverings and/or
different GROUPS.
Must control the same
set of window coverings
and/or GROUPS.
Resetting window covering programming
This reset erases all programming stored in the window
covering, including GROUP assignments, preventing any
input device from operating the window covering. Its primary
use is during installation to correct GROUP and Network
assignments. This reset does not affect travel limits.
1. Press and hold the manual control button for 12 seconds.
The window covering will move slightly once after 6
seconds, then again after 12 seconds. Release the button.
2. Refer to “Join a window covering to a GROUP” on
page 14 to program the window covering to a group.
PROGRAMMING
To Next Page
Loading...
Need help?
General