LuxaFlex PowerView Motorisation Guide

Creating a Duplicate Remote
A duplicate remote will operate the same set of window
coverings and GROUPS as the original remote.
1. Remove the back cover from the new remote.
2. Press and hold the recessed Reset button for 6 seconds,
until the GROUP buttons flash twice. Reinstall the back
cover.
3. Press and hold STOP for 4 seconds on the original
remote to put it in program mode. The backlit buttons on
the remote will flash to indicate it is in program mode.
4. While pressing and holding ALL on the new remote,
press and release STOP on the original remote.
5. The backlit GROUP buttons on the duplicate remote will
flash twice to indicate all of the information from the
original remote has been copied.
6. Press and hold STOP for 4 seconds on the original
remote to exit program mode.
Deactivating the remote(s) auto-wake
feature.
The auto-wake feature activates the backlights on the
remote, whenever the remote is handled. This feature is
useful for immediately seeing which shade group buttons
were activated last, but deactivating this feature will help to
conserve battery life.
1. PRESS and HOLD the Group 6 button on the remote for
approximately six seconds.
2. The Group numbers (1-6) will blink once to indicate the
auto-wake feature has been disabled.
18
PROGRAMMING

LuxaFlex PowerView Motorisation Specifications

General

Brand	LuxaFlex
Model	PowerView Motorisation
Category	Remote Control
Language	English