LuxaFlex PowerView Motorisation Guide

17
Pairing remote(s) to a PowerView Hub
created PowerView Shade Network.
A Hub previously paired to an existing remote created
PowerView Shade Network or that had created its own
network during setup, can have additional Pebble
®
or Surface
remotes paired to it, even if the remotes are introduced after
the initial Hub setup.
1. REMOVE the back cover on the remote module.
2. Using a ballpoint pen, PRESS and HOLD the recessed
Reset button for 6 seconds.
NOTE: The Group Numbers (1-6) will flash twice on
the PRESS of the reset button followed by three times
at six seconds.
3. HOLD the Remote module within approximately
12 inches of the Hub.
Complete Steps 4 and 5 at the same time.
4. PRESS and HOLD the STOP button on the remote
module.
5. PRESS and hold the button on the back of the Hub
for approximately 3 seconds.
NOTE: The Group Numbers (1-6) will flash to indicate
that the remote module has been networked to the Hub.
P
PROGRAMMING

LuxaFlex PowerView Motorisation Specifications

General

Brand	LuxaFlex
Model	PowerView Motorisation
Category	Remote Control
Language	English