LuxaFlex PowerView Motorisation Guide

16
Pairing PowerView Repeaters to a remote
created PowerView Shade Network.
Repeaters extend the range of the radio frequency (RF)
signal emitted by the PowerView Pebble
®
Remote, the
PowerView Surface, or the PowerView Hub when used with
the PowerView App.
1. ASSEMBLE the Repeater Kit by INSERTING the USB end
of the PowerView Repeater into the USB port of the USB
Power Supply.
2. PLUG the Repeater Kit into an electrical outlet, with
the Repeater facing up.
NOTE: A green light will illuminate on the Repeater
indicating it is receiving power and ready to join a
network.
3. PRESS and HOLD STOP on the PowerView Pebble
Remote until indicator lights on the interior of the remote
blink to put the remote in programming mode.
Hold the remote within 3 feet of the Repeater to complete
Step 4.
4. PRESS STOP on the remote.
NOTE: The green light will turn off, indicating it has been
joined to the network.
5. PRESS and HOLD STOP on the remote until the
indicator lights stop blinking.
PROGRAMMING

LuxaFlex PowerView Motorisation Specifications

General

Brand	LuxaFlex
Model	PowerView Motorisation
Category	Remote Control
Language	English